| Linear
Delta 3 Radio Controls Our popular Delta 3 line offers 256 codes and a 310 MHz frequency, which is ideal for most sites. • Multi Door Controllers • Single Door Controllers • Telephone Entry with Access Ctrl. • Accessories • Telephone Entry • Transmitters • Residential Telephone Entry • MultiCode Transmitters • MultiCode Keypads • MultiCode Receivers • MegaCode Transmitters • MegaCode Keypads • MegaCode Receivers • Delta3 Transmitters • Delta3 Keypads • Delta3 Receivers • Linear Building and Gated Community Access Controls • Linear Radio Controls • |
  |
||
 |
|||
Receivers |
|||
| 1-channel Receiver Model Number: DR Activates one device Wire lead antenna 12 and 24 Volt models Mounting bracket supplied Power: 24 Vac/Vdc Frequency: 310 MHz Codes: 256 (set by dip switches) Dimensions: 5.5 x 1.25 x 4 inches |
|||
|
|||
| 2-channel Receiver Model Number: DR-2 The Delta-3 DR-2 2-channel Receiver is a two-channel wireless radio control designed for use with automatic garage/gate operators and access control systems. The receiver can be activated by any of the Delta-3 format transmitters. Activates two devices Wire lead antenna 12 and 24 Volt models Mounting bracket supplied Power: 24 Vac/Vdc Frequency: 310 MHz Codes: 128 (set by dip switches) Dimensions: 5.5 x 1.25 x 4 inches |
|||
|
|||
| 4-channel Receiver Model Number: DR-4 The Delta-3 DR-4 4-channel Receiver is a wireless radio control designed for use with automatic garage/gate operators and access control systems. The receivers can be activated by any of the Delta-3 format transmitters. Activates four devices or UP, DOWN, STOP COMMERCIAL Wire lead antenna 12 and 24 Volt models Mounting bracket supplied Power: 24 Vac/Vdc Frequency: 310 MHz Codes: 64 (set by dip switches) Dimensions: 4.9 x 1.3 x 4.2 inches |
|||
|
|||
| 1-channel 12-volt Receiver Model Number: DRA The Delta-3 DRA 1-channel 12-volt Receiver is a small economical unit designed for commercial gate and door access control. It is compatible with solid state control boards. Upon receipt of a properly coded signal from a transmitter, it provides a switch operation for both NO and NC circuits. Any Delta-3 transmitter may be coded to activate this receiver, and any number of transmitters may be used to operate this receiver. In addition, the DRA may be programmed to respond to one of 256 digital codes. Activates one device Wire lead antenna 12 and 24 Volt models Mounting bracket supplied Power: 12 Vac/Vdc Frequency: 310 MHz Codes: 256 (set by dip switches) Dimensions: 5.5 x 1.25 x 4 inches |
|||
|
|
|||
| 4-channel 12-volt Receiver Model Number: DRA-4 12-volt, four-channel receiver with Form "C" relay outputs for residential or commercial applications, can be used for Up, Down, and Stop commercial operator control, 64 selectable codes. Activates four devices or UP,DOWN, STOP Wire lead antenna Mounting bracket supplied |
|||
|
|
|||
| 1-channel Gate Receiver Model Number: GRD (Replaces
the DRG and DRG-LV) The GRD is a 1-channel Gate Receiver designed for use with automatic gate operators or systems where a remote antenna is needed. Uses Linear's popular Delta-3 format 12-24 Volts AC or DC Auto voltage sensing - no jumpers to set Single relay Supplied with whip antenna, three feet of coaxial cable, and bulkhead connector Power: 12 - 30 VAC or 10.5 - 30 VDC Dimensions: 3.625 x 5.25 x 1.5 inches |
|||
|
|
|||
| 2-channel Gate Receiver Model Number: GRD-2 GRD (Replaces
the DRG-2 and DRG-2-LV) The GRD-2 2-channel Gate Receiver will operate two gates, one gate and an obstacle sensor, or channel one can open the gate and channel two can close the gate. Uses Linear's popular Delta-3 format 12-24 Volts AC or DC Auto voltage sensing - no jumpers to set Two relay Supplied with whip antenna, three feet of coaxial cable, and bulkhead connector Power: 12 - 30 VAC or 10.5 - 30 VDC Dimensions: 3.625 x 5.25 x 1.5 inches |
|||
|
|
|||
 |
1-channel Built-in Receiver Model Number: DRM |
||
|
|
|||
 |
1-channel Gate Receiver Model Number: DRQP The DRQP 1-channel Gate Receiver is a high-sensitivity, short-range radio receiver that operates in conjunction with the 9-inch local antenna (supplied). The DRQP is designed for use with automatic gate operators or systems where a remote antenna is needed. Manual |
||
|
|||
